Differences

This shows you the differences between two versions of the page.

--- en:aras [2019/01/02 15:34] – [Construction of antennae array] fluktuacia
+++ en:aras [2019/01/02 15:35] – [Construction of antennae array] fluktuacia
@@ Line 15: / Line 15: @@
 ==== Construction of antennae array ====
-It should be possible to lay out the horizontal loop above the ground using four non-conductive columns. Power supply for the loop can be brought by means of one of the columns - the impedance transformer to 50 Ohm will be directly on the loop. The signal will be further transferred by a short coaxial cable to [[en:bp|BP01A]] filter, positioned on a column and then to a preamplifier, consisting of [[en:gb|GB01A]] module. From that point on, the SMA connector can be reduced to a better quality coaxial cable with larger diameter, which can lead the signal to the receiver. There can be another selective filter and amplifier at the receiver.
+It should be possible to lay out the horizontal loop above the ground using four non-conductive columns. Power supply for the loop can be brought by means of one of the columns - the impedance transformer to 50 Ohm will be directly on the loop. The signal will be further transferred by a short coaxial cable to [[en:bp|BP01A]] filter, positioned on a column and then to a preamplifier, consisting of [[en:gb|GB01A]] module. From that point on, the SMA connector can be reduced to a better quality coaxial cable with a larger diameter, which can lead the signal to the receiver. There can be another selective filter and amplifier at the receiver.
 ===== Receiver and signal processing =====