Page locked

This page is currently locked for editing by another user. You have to wait until this user finishes editing or the lock expires.

Currently locked by:
Lock expires at: 2025/09/05 05:43 (15 min)

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

======  Xilinx Virtual JTAG Cable with USB FTDI chip FT220X ======

[[http://www.mlab.cz/Modules/CPLD_FPGA/XILINX_XVC/XVC_FT220X02A/DOC/XVC_FT220X02A.cs.pdf|Original document XVC_FT220X02A]]

It's a set of software and electronic hardware created by [[cs:credits|MIHO]]. It is intended to obtain a more accessible method of programming Xilinx FPGAs. More documents describing this method are available on 
[[http://www.mlab.cz/Server/GenIndex/GenIndex.php?path=%2FModules%2FCPLD_FPGA%2FXILINX_XVC&lang=cs|MLAB documents list page]].

===== Description of solution =====

To work with Xilinx FPGA it is necessary to use a hardware programmer. It allows a loading of a binary scheme into the chip. This can be realized by connecting the FPGA chip to the JTAG interface device.

XILINX ISE development suite for FPGAs supports XVC protocol. This protocol allows a remote TCP/IP connection to the JTAG device which is connected to the FPGA chip at the remote end.

==== Working principle ====

This module creates the virtual JTAG cable to the FPGA. This is based on FTDI FT220X USB interface chip and JTAG connector on its pins. Communication itself is realized over TCP/IP network thus of this FPGA can be located outside of developer working place. The whole process is illustrated on following picture:

==== Electronic construction ====

The module contains minimum number of parts because majority of functionality components are included in a  control software. So the most important for user are some connectors and indicating LEDs with following meaning:

There are two jumpers on the board of module: Jumper J3 marked as VIO PWR - this jumper selects JTAG working voltage (Internal 3.3 V regulated by FTDI chip or TGT voltage from JTAG connector).

Jumper 4 provides +5V power to target device from USB.

==== Use of XVC module ====

For use of this module XILINX development suite with iMPACT software is needed. In addition you need mlab_xvcd service utility.

=== Service software ===

The XVC module is controlled by OpenSource software [[cs:xvc_software|mlab_xvcd]]. This utility is fully supported in windows operating system Linux version is in development stage.

=== Use of XILINX ChipScope ===

ChipScope is valuable tool enabling the monitoring of internal octions in FPGA by integrated logical analyzer. It can be used in combination with XVC system.

==== System limitation ====

This XVC system currently are not able to write to FPGA internal FLASH memory (due to software limitations). Then schema binary must be loaded after every power up cycle or [[en:jtagft2232v|JTAGFT2232V02A]] programmer must be used.

===== Related designs =====

* [[en:s3an|S3AN01A]] - FPGA school board

Please fill all the letters into the box to prove you're human. K K K N O Please keep this field empty:

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International