Je vyrobený prototyp. V současné době probíhá jeho testování.

LEON-G100 / LEON-G200 modules can be switched on in one of the following ways:

• Rising edge on the VCC pin to a valid voltage as module supply, i.e. applying module supply
• Shorting PWR_ON pin to ground: the PWR_ON pin requires an external pull-up resistor to set its value to logic high and must not be left floating. Internal circuitry is low level sensitive
• RTC alarm, i.e. pre-programmed scheduled time (refer to u-blox AT Commands Manual [4], AT+CALA)
• Charger detection on the V_CHARGE and CHARGE_SENSE pins (LEON-G200 only)