en:altimet
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:altimet [2018/12/30 14:22] fluktuacia [Communication with sensors] |
en:altimet [2018/12/30 14:24] (current) |
||
|---|---|---|---|
| Line 30: | Line 30: | ||
| ===== Parameters ===== | ===== Parameters ===== | ||
| - | When measuring the parameters of MPL3115A2 during the [[en:abl|ABL01A]] project, we found out that the pressure measurements were functional at least up to 16 km (approximately 10kPa), a much better than the parameter stated in the catalogue list. On the other hand, the internal pressure atmospheric model is only usable up to 10 km of altitude - in higher altitudes it experiences considerable inaccuracies. | + | When measuring the parameters of MPL3115A2 during the [[en:abl|ABL01A]] project, we found out that the pressure measurements were functional at least up to 16 km (approximately 10kPa), a much better result than the parameter stated in the catalogue list. On the other hand, the internal pressure atmospheric model is only usable up to 10 km of altitude - in higher altitudes it experiences considerable inaccuracies. |
| Line 40: | Line 40: | ||
| - | Reading the pressure via I2C bus, a following python code was used: [[https://github.com/MLAB-project/MLAB-I2c-modules|Externí odkaz]] | + | Reading the pressure via I2C bus, a following python code was used: [[https://github.com/MLAB-project/MLAB-I2c-modules|External link]] |
| ==== Modul power supply ==== | ==== Modul power supply ==== | ||
en/altimet.1546176140.txt.gz · Last modified: 2018/12/30 14:22 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
