Differences

This shows you the differences between two versions of the page.

--- en:aras [2019/01/02 15:34] – [Construction of antennae array] fluktuacia
+++ en:aras [2019/01/02 15:36] – [Data processing software for station] fluktuacia
@@ Line 15: / Line 15: @@
 ==== Construction of antennae array ====
-It should be possible to lay out the horizontal loop above the ground using four non-conductive columns. Power supply for the loop can be brought by means of one of the columns - the impedance transformer to 50 Ohm will be directly on the loop. The signal will be further transferred by a short coaxial cable to [[en:bp|BP01A]] filter, positioned on a column and then to a preamplifier, consisting of [[en:gb|GB01A]] module. From that point on, the SMA connector can be reduced to a better quality coaxial cable with larger diameter, which can lead the signal to the receiver. There can be another selective filter and amplifier at the receiver.
+It should be possible to lay out the horizontal loop above the ground using four non-conductive columns. Power supply for the loop can be brought by means of one of the columns - the impedance transformer to 50 Ohm will be directly on the loop. The signal will be further transferred by a short coaxial cable to [[en:bp|BP01A]] filter, positioned on a column and then to a preamplifier, consisting of [[en:gb|GB01A]] module. From that point on, the SMA connector can be reduced to a better quality coaxial cable with a larger diameter, which can lead the signal to the receiver. There can be another selective filter and amplifier at the receiver.
 ===== Receiver and signal processing =====
@@ Line 33: / Line 33: @@
 Second is the realisation of PC’s driver, which would make it possible to reconstruct the former RF signal from data transferred to DMA for their further processing by parent applications (e.g. [[https://github.com/MLAB-project/radio-observer|Radio-Observer]]).
-A general problem of this construction will be a need for massive reduction of data flow - this problem can however be resolved in a later application phase. Necessary computing power can be obtained either by changing the FPGA scheme that will preprocess the signal (e.g. filtration, decimation, demodulation) or by using PC’s GPU that can process parallel operations such as getting information about correlation of individual channels.
+A general problem of this construction will be a need for massive reduction of data flow - this problem can be however resolved in a later application phase. Necessary computing power can be obtained either by changing the FPGA scheme that will preprocess the signal (e.g. filtration, decimation, demodulation) or by using PC’s GPU that can process parallel operations such as getting information about correlation of individual channels.