Differences

This shows you the differences between two versions of the page.

--- en:i2c [2014/12/21 10:34] – [Use of Linux kernel drivers] fluktuacia
+++ en:i2c [2014/12/21 10:42] – [Convertors to connect I²C to PC] kaklik
@@ Line 38: / Line 38: @@
 ===== Convertors to connect I²C to PC =====
-Although I²C is quite popular bus suitable to connect different sensors over short distances, it is not usually found and readily available on regular computers with exception of [[http://www.paintyourdragon.com/?p=43|DCC leading out of free display port.]]
+Although I²C is quite popular bus suitable to connect different sensors over short distances, it is not usually found and readily available on regular computers. (([[http://www.paintyourdragon.com/?p=43|with exception of DCC leading out at free display port.]]))
 ==== USB interface ====
@@ Line 134: / Line 134: @@
 Some I²C devices have their drivers directly in the linux kernel allowing an access directly through file system. It applies to following MLAB modules:
-  * [[cs:usbi2c]]
+  * [[en:usbi2c]]
-  * [[cs:i2chub]]
+  * [[en:i2chub]]
-  * [[cs:i2cspi]]
+  * [[en:i2cspi]]
 Due to the fact that, in principle, I²C is not a [[http://en.wikipedia.org/wiki/Plug_and_play|plug-and-play]] bus, every connected device must be explicitly reported to the kernel. A general procedure of such connection is via a following command: