en:lna
Differences
This shows you the differences between two versions of the page.
Previous revision | |||
en:lna [2013/07/24 21:32] – [Covering] kaklik | — | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Low-noise amplifier LNA01A ====== | ||
- | |||
- | A low-noise preamplifier module ([[http:// | ||
- | |||
- | |||
- | ===== Construction ===== | ||
- | |||
- | The connection of the amplifier is implemented using the FR4 PCB. It is possible to fit the PCB with straight SMA connectors or edge connectors. The amplifier is expected to be placed inside the metallic shielding box. | ||
- | |||
- | The following scheme shows the circuit of the module: [[http:// | ||
- | |||
- | |||
- | ===== Tuning ===== | ||
- | |||
- | The amplifier tuned to 143MHz band: | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | |||
- | The transmission curve of the LNA01A. | ||
- | Smaller horizontal lines in the upper part of the screen have a scale increment of 10MHz, increment for larger lines is 100MHz and 200MHz. The gain is approximately 27 dB. | ||
- | |||
- | {{: | ||
- | |||
- | A coil performing on 144Mhz has 7 turns of 0.5mm wire around a rod with a diameter of 4mm (__a drill__). The coil is ..? | ||
- | |||
- | Cívka pro naladění na 143 MHz vychází 7 závitů z měděného drátu průměru 0,5 mm motáno na průměr tyčky 4mm (vrták). Cívka je roztažená tak jak je vidět na fotografii. Kondenzátory C1 a C2 jsou 8,2 pF. Zpětná vazba u LNA není potřeba, pouze zvyšuje šumové číslo a snižuje zisk asi o 1dB. Trim je nahrazen odporem | ||
- | |||
- | ====== The measured parameters ====== | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | {{: | ||
- | |||
- | ===== Applications ===== | ||
- | |||
- | This preamplifier is primarily constructed for use in combination with SDR receiver [[en: | ||
- | |||
- | |||
- | ===== Covering ===== | ||
- | |||
- | The module fits into metallic shielding box[[http:// | ||
- | |||
- | |||
- | == References == | ||
- | * [[http:// | ||
en/lna.txt · Last modified: 2015/03/23 16:54 (external edit)