User Tools

Site Tools


en:lna

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
en:lna [2013/07/24 17:36] fluktuaciaen:lna [Unknown date] (current) – external edit (Unknown date) 127.0.0.1
Line 6: Line 6:
 ===== Construction ===== ===== Construction =====
  
-The connection of the amplifier is implemented using the FR4 PCB. It is possible to fit the PCB with __straight__ SMA connectors or __edge__ connectors. The amplifier is expected to be placed inside the __metallic tin shielding can__.+The connection of the amplifier is implemented using the FR4 PCB. It is possible to fit the PCB with straight SMA connectors or edge connectors. The amplifier is expected to be placed inside the metallic shielding box.
  
-The following scheme shows the connecting of the module: [[http://www.mlab.cz/WebSVN/filedetails.php?repname=MLAB&path=%2FModules%2FCommRF%2FLNA01A%2FSCH%2FLNA.pdf| LNA01A scheme]]. +The following scheme shows the circuit of the module: [[http://www.mlab.cz/WebSVN/filedetails.php?repname=MLAB&path=%2FModules%2FCommRF%2FLNA01A%2FSCH%2FLNA.pdf| LNA01A scheme]]. 
  
  
 ===== Tuning ===== ===== Tuning =====
  
-Zesilovač naladěný na pásmo 143MHz vypadá takto:+The amplifier tuned to 143MHz band:
  
-{{:cs:lna01a_assembled.jpg?direct&200|Složený předzesilovač LNA01A bez krabičky}}+{{:cs:lna01a_assembled.jpg?direct&200|Assembled preamplifier LNA01A without the shielding can.}}
  
-{{:cs:lna01a_measuring_setup.jpg?direct&200|Měřící uspořádání předzesilovače}}+{{:cs:lna01a_measuring_setup.jpg?direct&200|Arrangement for measuring.}}
  
-Přenosová charakteristika nízkošumového předzesilovače LNA01A. Menší horizontální čárky v horní části stínítka jsou po 10MHz vetší jsou 100 a 200MHz. Zisk je cca 27 dB. +The transmission curve of the LNA01A. 
 +Smaller horizontal lines in the upper part of the screen have scale increment of 10MHz, increment for larger lines is 100MHz and 200MHz. The gain is approximately 27 dB.  
  
-{{:cs:lna01a_transmission_curve.jpg?direct&200|Přenosová frekvenční charakteristika LNA01A}}+{{:cs:lna01a_transmission_curve.jpg?direct&200|LNA01A transmission curve}}
  
-Cívka na 144MHz vychází 7závitů z drátu 0,5mm motáno na průměr tyčky 4mm (vrták). Cívka je roztažená tak jek je vidět na fotce C1 C2 je 8,2pFZpětná vazba u LNA není vyhodil jsem ji není tam potřebadomnívám se že zvyšuje šumové číslo a snižuje zisk asi o 1dB. Trim tam taky nedávám je tam odpor 45 Ohm celkový proud celým LNA by měl být kolem 153mA, potom je proud kolektorem asi 135mA.+A coil performing on 144Mhz has 7 turns of 0.5mm wire around a rod with a diameter of 4mm (__a drill__). The coil is stretched as seen in the picture. The capacitors C1 and C2 have the capacitance of 8,2 pFIt is not necessary to use a feedback on LNA, as it increases the __s/n ratio__ and decreases the gain by approximately 1dB. A trim is replaced by 45 Ω resistor and the total current through the LNA should be around 153mA. The current through source transistor is than about 135mA. 
  
-====== Naměřené parametry ======+====== The measured parameters ======
  
-{{:cs:prenos.png?200|}}+{{:cs:rf:lna01a.png?400|Transmission characteristic of LNA01A preamplifier.}}
  
 {{:cs:lna_-10dbm_in.png?200|}} {{:cs:lna_-10dbm_in.png?200|}}
 {{:cs:lna01a_-20dbm_in.png?200|}} {{:cs:lna01a_-20dbm_in.png?200|}}
  
-===== Použití =====+===== Applications =====
  
-Tento předzesilovač je primárně konstruovaný pro použití v kombinaci s SDR přijímačem [[cs:sdrx|SDRX01B]]. Jeho vlastnosti jsou optimálizovány pro použití v radioastronomii, nebo kosmickém výzkumu.+This preamplifier is primarily constructed for use in combination with SDR receiver [[en:sdrx|SDRX01B]]. Its characteristics are optimized for use in radioastronomy or cosmic research
  
-===== Zakrytování ===== 
  
-Modul pasuje do kovové cínované stínící krabičky [[http://www.gme.cz/plechove-krabicky-stinici-cinovane/u-ah101-p622-024/|U-AH101]]+===== Covering =====
  
 +The module fits into metallic shielding box[[http://www.gme.cz/plechove-krabicky-stinici-cinovane/u-ah101-p622-024/|U-AH101]]
  
-== Reference == + 
-  * [[http://www.ha8et.hu/PDF/EXTRA-2%20144%20MHz%20Contest%20Preamplifier.pdf|Extra-2]] - původní konstrukce od HA8ET+== References == 
 +  * [[http://www.ha8et.hu/PDF/EXTRA-2%20144%20MHz%20Contest%20Preamplifier.pdf|Extra-2]] - the original HA8ET construction
  
en/lna.1374687360.txt.gz · Last modified: 2013/07/24 17:36 by fluktuacia