Differences

This shows you the differences between two versions of the page.

--- en:navody [2019/01/31 14:10] – [Measuring arrangement] fluktuacia
+++ en:navody [2019/01/31 14:11] – [Tower arrangement] fluktuacia
@@ Line 233: / Line 233: @@
 ==== Tower arrangement ====
-Metal MLAB mounts can be stack on onto another using threaded rods. Such arrangement saves space and enables a construction of a more complicated and extensive systems.
+Metal MLAB mounts can be stack on onto another using threaded rods. Such arrangement saves space and enables a construction of more complicated and large-scale systems.
 {{:mlab_tower.jpg?direct&200|Tower arrangement of MLAB boards}}
-The threaded rods used in the example are of M5 type and each board is fastened by a nut from above and below. There are washer between the board and the nuts. There is a spring washer used with one of the nuts. Cutting length (?? Řezná délka) in case of two boards above each other is 12 cm. This length was chosen because 1m threaded rod can be divided into 8 columns and there are 4cm left for cutout  (?? Prořez) and tolerance.
+The threaded rods used in the example are of M5 type and each board is fastened by a nut from above and below. There are washers between the board and the nuts. There is a spring washer used with one of the nuts. Cutting length (?? Řezná délka) in case of two boards above each other is 12 cm. This length was chosen because 1m threaded rod can be divided into 8 columns and there are 4cm left for cutout  (?? Prořez) and tolerance.
 ===== Permanent installations =====