Differences

This shows you the differences between two versions of the page.

--- en:pymlab [2017/12/14 23:39] – ondra6ak
+++ en:pymlab [2017/12/14 23:41] – MicroPytho documentation ondra6ak
@@ Line 78: / Line 78: @@
 Fortunately MicroPython provides cross compiler that allows us to compile the source code to bytecode and therefore reduce the RAM and flash usage.
-== Installation ==
 Version of the cross compiler must match the version of MicroPython running on your board. If in doubt just compile and flash your board with firmware compiled from the same branch of the [[https://github.com/micropython/micropython#the-stm32-version|MicroPython repository]] as the cross compiler, instruction can be found at [[https://github.com/micropython/micropython#the-stm32-version|https://github.com/micropython/micropython#the-stm32-version]].
@@ Line 92: / Line 90: @@
 </code>
-In  Makefile at [[https://github.com/MLAB-project/pymlab/blob/master/src/pymlab/Makefile|pymlab/src/pymlab/Makefile]] edit the path to the cross compiler, mountpoint of the flash memory and devices you wish to use (drivers for all devices are still to much for the limited space on Pyboard). The just 'make deploy'
+In  Makefile at [[https://github.com/MLAB-project/pymlab/blob/master/src/pymlab/Makefile|pymlab/src/pymlab/Makefile]] edit the path to the cross compiler, mountpoint of the flash memory and devices you wish to use as all drivers are still to much for the limited space on the Pyboard. The just type
+  make deploy
+and you are good to go.