MLAB wiki

User Tools

Site Tools

Trace:
en:rules

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
en:rules [2022/03/08 21:58] – [Manual module creation] kakliken:rules [2022/03/08 22:00] – [MLAB connectors configuration] kaklik
Line 42: Line 42:
 If for some reason, you are reluctant to use MLABgen for the creation of the basic directory structure, it is necessary to comply with the following rules:  If for some reason, you are reluctant to use MLABgen for the creation of the basic directory structure, it is necessary to comply with the following rules: 
  
-In the appropriate folder category, we create a folder with the name of the new module using the format ''NAMEVERREV’’ . Inside the folder, we create the following directory structure (obligatory folders/files are marked with an asterisk):+In the appropriate folder category, we create a folder with the name of the new module using the format of ''NAMEVERREV''. Inside the folder, we create the following directory structure (obligatory folders/files are marked with an asterisk): 
  
-'' 
   <NAMEVERREV>*   <NAMEVERREV>*
   ├── doc*   ├── doc*
Line 73: Line 73:
   ├── <NAMEVERREV>.json*   ├── <NAMEVERREV>.json*
   └── sw   └── sw
-      └── <NAMEVERREV>_exmalpe.py''+      └── <NAMEVERREV>_exmalpe.py
  
 The file ''<NAMEVERREV.json>'' should contain the information concerning the module. The file ''<NAMEVERREV.json>'' should contain the information concerning the module.
Line 108: Line 108:
 {{:low_power_connectors.png?direct&400|}}  {{:low_power_connectors.png?direct&400|}} 
  
-**Power supply connectors are doubled in order to allow smyčkování napájení (??).**+**Power supply connectors are doubled in order to allow power looping**
 ==== Externí napájecí zdroje ==== ==== Externí napájecí zdroje ====
  
en/rules.txt · Last modified: 2023/02/03 00:14 by kaklik